Accessible surface differences between the open and closed structures. (A; middle) Accessible surface plots (made using CAVER software; Chovancova et al., 2012) showing radius versus distance through the central axis of the pore for Closed_Ab-I217C (slate blue), Closed_Ae (red), Inactivated_Ab (gray), Open_Ms (light green), and pOpen_Ms (turquoise). (Left and right) Slab surface mode/cartoon depictions of the pores, sliced along the transmembrane direction for the Closed_Ab (left, slate blue) and Open_Ms (right, light green) pores, highlighting the sites of the first minor constriction (blue underlay: present for both forms with the responsible residues, V213 in the closed form and I215 in the open form), the second minor construction (orange underlay: present only in the closed form, residue I217C), and the third major constriction (yellow underlay: present only for the closed form, residue M221) at the intracellular end of the cavity. I217C is the mutation in the closed structure that enabled crystallization at higher resolution. (B) Detailed view of the three “hydrophobic constriction” (HC) regions noted above shown in cartoon and stick mode for the Closed_Ab (slated blue) and Open_Ms (light green) structures. The distances shown were measured between two diagonally opposite residues. It is clear that the narrow constrictions at HC2 and HC3 (6.62 and 4.81 Å) seen in the closed structure are not present in the open structure (where the equivalent distances are 14.84 and 17.18 Å).